After I got my JTech laser attached to my X-Carve CNC I was a bit of a loss. I was not sure what to do next. What settings do I need to set? How do I set up my software? Wait, what software do I want to use???
I searched the internet and was unable to find any 'getting started' guide so I decided to write my own. This site describes how I started using my laser and what I learned as I went along. This site is not meant to promote one method or software package over another. It is, based on my experience, a guide to getting started - it is what I would tell a friend if they asked me, "Hey, I got it all set up. What do I do next?"
So, the purpose of this site is to share my learnings, mishaps, and successes of my laser engraving and to, hopefully, help others who may be coming up behind me.
What I share is what I have experienced. I do not present any of it as being the only or best way.
Also, and most importantly, be safe - your safety is your responsibility. These lasers are both dangerous to the eyes and are a fire risk. Be sure to wear eye protection, watch out for others who may unknowingly enter the area, and keep a fire extinguisher near by.
No comments:
Post a Comment